WAC 296-150C-0500
When is an inspection required? (1)
Before we issue an insignia, each unit manufactured or converted
must be inspected as many times as required to show compliance
with this chapter.
Note:
Each commercial coach must have a serial number so we can track inspections.
(2) Before we issue an insignia, each commercial coach must
be inspected at the manufacturing location as many times as
required. Inspections may include but are not limited to:
(a) A "cover" inspection during construction of the unit
before the electrical, plumbing, mechanical, and structural
systems are covered;
(b) Insulation and vapor barrier inspection, if required;
and
(c) A final inspection after the commercial coach is
complete.
(3) If we discover a violation during inspection, we will
issue a notice of noncompliance. You can correct the violation
during the inspection. If you cannot correct the violation
during inspection, you must leave the item uncovered until we
approve your correction.
(4) If a commercial coach is damaged in transit to the
building site or during on-site installation, it must be
inspected. This is considered an alteration inspection. (See
WAC 296-150C-0240.)
(5) Approved design plans must be available in compliance
with the applicable sections of the adopted state codes.
(6) Once your unit is inspected and approved we will attach
the insignia.