WAC 173-240-050
General sewer plan. (1) All general sewer
plans required of any governmental agency before providing sewer
service are "plans" within the requirements of RCW 90.48.110. Three copies of the proposed general sewer plan and each
amendment to it must be submitted to and approved by the
department before implementing the plan.
(2) The general sewer plan must be sufficiently complete so
that engineering reports can be developed from it without
substantial alterations of concept and basic considerations.
(3) The general sewer plan shall include the following
information together with any other relevant data as requested by
the department. To satisfy the requirements of the local
government jurisdiction, additional information may be necessary.
(a) The purpose and need for the proposed plan.
(b) A discussion of who will own, operate, and maintain the
systems.
(c) The existing and proposed service boundaries.
(d) Layout map including the following:
(i) Boundaries. The boundary lines of the municipality or
special district to be sewered, including a vicinity map;
(ii) Existing sewers. The location, size, slope, capacity,
direction of flow of all existing trunk sewers, and the
boundaries of the areas served by each;
(iii) Proposed sewers. The location, size, slope, capacity,
direction of flow of all proposed trunk sewers, and the
boundaries of the areas to be served by each;
(iv) Existing and proposed pump stations and force mains. The location of all existing and proposed pumping stations and
force mains, designated to distinguish between those existing and
proposed;
(v) Topography and elevations. Topography showing pertinent
ground elevations and surface drainage must be included, as well
as proposed and existing streets;
(vi) Streams, lakes, and other bodies of water. The
location and direction of flow of major streams, the high and low
elevations of water surfaces at sewer outlets, and controlled
overflows, if any. All existing and potential discharge
locations should be noted; and
(vii) Water systems. The location of wells or other sources
of water supply, water storage reservoirs and treatment plants,
and water transmission facilities.
(e) The population trend as indicated by available records,
and the estimated future population for the stated design period.
Briefly describe the method used to determine future population
trends and the concurrence of any applicable local or regional
planning agencies.
(f) Any existing domestic or industrial wastewater
facilities within twenty miles of the general plan area and
within the same topographical drainage basin containing the
general plan area.
(g) A discussion of any infiltration and inflow problems and
a discussion of actions that will alleviate these problems in the
future.
(h) A statement regarding provisions for treatment and
discussion of the adequacy of the treatment.
(i) List of all establishments producing industrial
wastewater, the quantity of wastewater and periods of production,
and the character of the industrial wastewater insofar as it may
affect the sewer system or treatment plant. Consideration must
be given to future industrial expansion.
(j) Discussion of the location of all existing private and
public wells, or other sources of water supply, and distribution
structures as they are related to both existing and proposed
domestic wastewater treatment facilities.
(k) Discussion of the various alternatives evaluated, and a
determination of the alternative chosen, if applicable.
(l) A discussion, including a table, that shows the cost per
service in terms of both debt service and operation and
maintenance costs, of all facilities (existing and proposed)
during the planning period.
(m) A statement regarding compliance with any adopted water
quality management plan under the Federal Water Pollution Control
Act as amended.
(n) A statement regarding compliance with the State
Environmental Policy Act (SEPA) and the National Environmental
Policy Act (NEPA), if applicable.
[Statutory Authority: RCW 90.48.110. 00-15-021 (Order 00-09), §
173-240-050, filed 7/11/00, effective 8/11/00. Statutory
Authority: Chapters 43.21A and 90.48 RCW. 83-23-063 (Order DE
83-30), § 173-240-050, filed 11/16/83. Statutory Authority: RCW 90.48.110. 79-02-033 (Order DE 78-10), § 173-240-050, filed
1/23/79. Formerly chapter 372-20 WAC.]